Thermostat Replacement For Toyota Mr 2 Mki Aw10 Aw11 1984 1989 Engine Call it a "how to" if you like we'd prefer "cautionary tale" the mr2 decided to overheat on ian and miles at the last rallycross event so action must be. A) with some empty space below your filler cap (just drain about 300ml from the rad drain plug) add the flushing agent (i used xado rad flush) to your cooling system. shut rad cap. allow engine to run & for a few min after thermostat opens. in our case, about 15 20 min with rug on engine & cooling fan unplugged at 25 degrees atmospheric temp.
How To Change Flush The Coolant In The Toyota Mr2 Mk1 Aw11 Youtu A step by step summary of what to do to flush the coolant system in the toyota mr2 mk1. this is a long process and must be done thoroughly to ensure that the. J. jlevy. 119 posts · joined 2012. #2 · feb 5, 2013 (edited) the radiator is pretty easy to remove. just remove the spare tire well and any upper plastic in that area, remove the plastic housing containing the 2 fans (2 bolts, 2 connectors, 1 wire clip), disconnect the 2 radiator hoses, remove the 2 brackets holding the radiator in place (one. 13. start slowly pouring mixture of toyota red coolant and distilled water (50 50) into coolant line (in engine bay, where the radiator cap goes). when the coolant in the two hoses in the front trunk rises up to the same level as the radiator cap, the system is close to “full.” 14. put radiator cap on and turn to the first position. 15. Got quote for $26 for the thermostat and $16.84 per litre for the coolant (ouch) $117.84 total for the coolant concentrate (@7ltrs). guest of the club. by mr2boy23 » mon dec 07, 2009 9:59 pm. yup get demineralised water from supercheap auto. guest of the club.
Coolant Flush Toyota Mr2 Graysgarage Ca At Gray S Garage 13. start slowly pouring mixture of toyota red coolant and distilled water (50 50) into coolant line (in engine bay, where the radiator cap goes). when the coolant in the two hoses in the front trunk rises up to the same level as the radiator cap, the system is close to “full.” 14. put radiator cap on and turn to the first position. 15. Got quote for $26 for the thermostat and $16.84 per litre for the coolant (ouch) $117.84 total for the coolant concentrate (@7ltrs). guest of the club. by mr2boy23 » mon dec 07, 2009 9:59 pm. yup get demineralised water from supercheap auto. guest of the club. Bibbs. first step for me would be get the front of the car up in the air, open the tap on the rad and get a hosepipe on the radcap in the engine bay. force the water through. then get the rad closed, drop the front, let it idle for ages with the cap off keep bouncing on the door sills and rock any air locks out. Just bought my first mr2, its an 88 and i'm loving it but it is in need of a full coolant hose replacement. i've been searching the forum and auto part sites and have come up with the following list. toyota part numbers: 16573 16020 short hose from water pipe to oil cooler right side 16576 16030 long driver side hose from thermostat to water pipe.
Thermostat Replacement For Toyota Mr 2 Mki Aw10 Aw11 1984 1989 Engine Bibbs. first step for me would be get the front of the car up in the air, open the tap on the rad and get a hosepipe on the radcap in the engine bay. force the water through. then get the rad closed, drop the front, let it idle for ages with the cap off keep bouncing on the door sills and rock any air locks out. Just bought my first mr2, its an 88 and i'm loving it but it is in need of a full coolant hose replacement. i've been searching the forum and auto part sites and have come up with the following list. toyota part numbers: 16573 16020 short hose from water pipe to oil cooler right side 16576 16030 long driver side hose from thermostat to water pipe.
Replacement Of Refrigerant Lines Toyota Mr2 Mk1 1989 Aw11 Repair
Comments are closed.