Filling And Bleeding The Cooling System On A Gm 3 8l Youtube Today's helpful how to video will be on bleeding your gm 3.8l engine, its a simple and easy to do step that you may need to do each time you replace your rad. Dec 14, 2010. #3. open the bleeder on a cold engine, add as much coolant as it will take through the radiator. close bleeder. run engine and add to radiator as necessary while it warms up. install cap, allow to build pressure and get up to normal operating temp. open bleeder while running at this point.
Bleed Cooling System Chevy Equinox After replacing several cooling system components, i filled the cooling system and bled the air out of the system. the spill free funnel is not a necessity b. 7.start the engine and allow the radiator fluid to flow throughout the system, bleed the air out at this time. run it for approximately 15 minutes, then shut it down and allow the engine to cool off. when the engine is cool, remove the radiator cover and top off both the radiator and the coolant overflow tank with the 50 50 mix. bleeding the air. Then torque your bolts to 8.75 lbs ft or 105 a inch, run your belt and fill and bleed your system. i use extended life universal antifreeze with no problems. took longer to bleed the system than anything else. you want to park facing up a hill and block your tires if your in a manual. For more info visit us at: 1aau.to h w in the video, 1a auto shows how to drain, flush, and refill your coolant. the video is applicable to the 09, 10.
2013 Chevy Malibu Coolant Bleeder Valve Location Then torque your bolts to 8.75 lbs ft or 105 a inch, run your belt and fill and bleed your system. i use extended life universal antifreeze with no problems. took longer to bleed the system than anything else. you want to park facing up a hill and block your tires if your in a manual. For more info visit us at: 1aau.to h w in the video, 1a auto shows how to drain, flush, and refill your coolant. the video is applicable to the 09, 10. Fill procedure: 1 close the radiator drain plug. 2 lower the vehicle. 3 vehicle should be level. 4 loosen the vent screw on the radiator. (vent screw is located at the top, right (passenger) side of the radiator) note: close vent screw when coolant begins to flow from the vent screw. The gasket problem happens on every single 3.1, 3.4, 3.8, 4.3, 5.0, 5.7, and 7.4 motor. every single uoa posted here with these engines shows coolant in the oil if it has the factory gaskets. the updated intake manifold came out with the series iii 3.8l in 2004, but people are still reporting gasket failures until about 2005.
Coolant Leak In 2014 Chevy Cruze Fill procedure: 1 close the radiator drain plug. 2 lower the vehicle. 3 vehicle should be level. 4 loosen the vent screw on the radiator. (vent screw is located at the top, right (passenger) side of the radiator) note: close vent screw when coolant begins to flow from the vent screw. The gasket problem happens on every single 3.1, 3.4, 3.8, 4.3, 5.0, 5.7, and 7.4 motor. every single uoa posted here with these engines shows coolant in the oil if it has the factory gaskets. the updated intake manifold came out with the series iii 3.8l in 2004, but people are still reporting gasket failures until about 2005.
Comments are closed.