Getting The Superjet Complete And Dual Cooling Setup Installed Youtube Now we have the motor complete time to install and get all the other pieces installed. if you want to see how dual cooling is done on tye yamaha 2 strokes t. Jul 27, 2010. #10. dual outlets can be run from single cooling. if you have moderate water temps and. severely restrict the pisser from the head. by running dual outlets from the head, it avoids hot spots. that can develop if you trap water. ada is designed for dual outlets. to optimize cooling of both cylinders. b.
Super Jet How To Run Dual Cooling Outlets X H2o Part 1prepping the superjet to install the factory pipe with dual cooling and other goodies. setting up the new pipe for dual cooling, removing old oem exhau. Tweet. #3. 08 29 2015, 11:48 am. re: modified 550 cooling routing. sorry for the crappy pictures, the routing is as follows. intake to exhaust manifold. rear side of the head to the lower nipple on the exhaust pipe. upper nipple on the exhaust pipe straight out. front side of the head straight out, and the stinger line on the half pipe. Tubbies are bolt on and take very little time to install. they can be removed easily depending on conditions or your riding style. these fit 2008 2018 and these fit 1994 2012. dual cooling. a dual cooling kit will keep your ski more reliable than stock in case of a blocked cooling pipe. this kit is cheap and gives you more piece of mild. Note: recommend maybe waiting to do the marine epoxy last. it's not necessary to do first, i think it might be easier to get everything fitted in first, th.
How To Dual Cooling Upgrade For Squarenose Superjet W Bilge Delete Youtube Tubbies are bolt on and take very little time to install. they can be removed easily depending on conditions or your riding style. these fit 2008 2018 and these fit 1994 2012. dual cooling. a dual cooling kit will keep your ski more reliable than stock in case of a blocked cooling pipe. this kit is cheap and gives you more piece of mild. Note: recommend maybe waiting to do the marine epoxy last. it's not necessary to do first, i think it might be easier to get everything fitted in first, th. Using carb cleaner, spray out the throat and plug holes of the carburetor. use compressed air to spray all of the cleaner out. take a flathead screwdriver to remove the stock adjustment screws, turning counterclockwise. place the jet down, and remove the spring, washer, and o ring from the screw. After completing installation of the dual cooling kit follow the instructions below. failure to run dual cooling can result in serious engine damage. remove the stock incoming waterline located next to the drive line coupler and retain the stock hose clamps. install the 3 8" x 52" waterline (item #11) where the stock incoming waterline was.
Comments are closed.