Engineering Graphics Line Projection Line Inclined To Both Short video explaining the step by step procedure to obtain projection of given line which is inclined to both reference planes (i.e. hp and vp) this is the. Line inclined to both the reference planes where angles made by line with reference planes is given in the question.
Projection Of Line Problem No 07 Line Inclined To Both The Referenc The document discusses different types of projections of points and lines in space. it describes 9 types of point projections based on their location relative to the horizontal and vertical planes. it then explains the different notations used for projecting lines, including their true length, front view length, top view length, and inclinations. The projection of a line is obtained by projected its finish points on planes of projections then connecting the points of projections. the projected length and inclination of a line, is totally different compared to its true length and inclination. the different cases are: . case 1. line parallel to a plane. case 2. line inclined to a plane. Engineering graphics | module 1 : projection of lines introduction to traces of a line.presented by: jeeno mathewcamera & editing: prof. jose tom tharappel. A straight line ab of 40 mm length has one of its ends a, at 10 mm from the hp and 15 mm from the vp. draw the projections of the line if it is parallel to the vp and inclined at 30° to the hp. assume the line to be located in each of the four quadrants by turns. (example) 30° x y a b a´ b´ 1 5 1 0 14 parallel to vp and inclined to hp 30.
Comments are closed.