Cooling Hook Up On The X2 With Pics And Diagram Re: cooling hook up on the x2 with pics and diagram the way ttts drew it up will definately work , the lower fitting on the westcoast pipe is feeding the chambe sonic wave. the way you drew it is fine but id make the straight through of the "t" goto the head pipe and the 90 degree off the "t" goto the fitting feeding the chamber sonic wave. Search in titles only search in kawasaki x2 only. search. advanced search.
Arctic Cooling Accelero X2 Review What S Inside Techpowerup Kawasaki x2 if this is your first visit, be sure to check out the faq by clicking the link above. you may have to register before you can post: click the register link above to proceed. Oct 8, 2013. #2. bare with me here, this is a 650 sx with kirker pipe, single cooling. i looked at some coffmans for the x2 on ebay and they have the same cooling fittings & cooling set up as this. the sx has two thru hull tubes, one of these two dumps to pump area but does not connect to the pump, i cap this tube off at the bulk head. The flow diagrams shown are different from mine as they show two hoses from the intake (raw water) one leading to the stat and one going to the pump for the exhaust maniflods, where mine on the 318 only has the one raw water inlet which divides at the stat housing for the exhaust manifolds and the engine. Once the water level is needing to be topped up, the level sensors will send a signal to the control valve to open, allowing fresh water to enter the system. ancillaries. pump – usually, due to the installation of the make up water tank, sometimes lower than the tower basin, there may need to be a requirement for the make up water to be.
Radiator Cooling Fan Wiring Diagram The flow diagrams shown are different from mine as they show two hoses from the intake (raw water) one leading to the stat and one going to the pump for the exhaust maniflods, where mine on the 318 only has the one raw water inlet which divides at the stat housing for the exhaust manifolds and the engine. Once the water level is needing to be topped up, the level sensors will send a signal to the control valve to open, allowing fresh water to enter the system. ancillaries. pump – usually, due to the installation of the make up water tank, sometimes lower than the tower basin, there may need to be a requirement for the make up water to be. If you have a c wire, place it into the c terminal on your wall plate. c wire adapters are available here. let’s look at the g wire. this wire goes to the g terminal on your new thermostat. of the y, y1, and y2 wires, y or y1 go to the y terminal and y2 to the y2 terminal. the o b wire can have many configurations. I hooked up the new stat the same way but it would not work. if i selected "fan on" instead of "fan auto" the zone would heat up but would not shut off (hot water kept flowing even if i selected a temp below room temp). appreciate your help. patrick 1 20 12. reply:.
Comments are closed.