Bmw E46 325i Thermostat Replacement Diy38 Youtube This is a 2002 bmw 325i⚠️ i'm not a certified auto mechanic i just love to work on my own cars so diy at your own risk ️always remember safety first!a. To remove the thermostat: remove the 11mm nut that holds the engine hoist bracket, remove the 13mm bolt of the lower part of engine hoist bracket, and the 3x10mm bolts that hold the thermostat on the block. have some rags below the thermostat as coolant (around 1.5l) will be spilled. you don't want coolant on the engine belt.
Diy How To Replace Thermostat Bmw E46 Youtube Bmw e46 thermostat replacement. how to replace thermostat on bmw 323i 325i 328i 330i 323ci 328ci 325ci 330ci our website: mechaniclifestyle we too. The following article provides detailed instructions on performing a thermostat replacement on a bmw e46 3 series car. even though we have used a 2003 bmw 325ci to perform this installation, this article can be applied to any e46 3 series vehicle, including the 323i, 328i and 330i coupe, sedan and convertible. Most of the time when you remove the old expansion tank the trans t stat will break. it is best to have one on hand and replace it. the expansion tank sits mounts on top of the automatic transmission thermostat. when you pull the old expansion tank off there's a chance the old thermostat will break. check out this video. 2005 325i e46, automatic trans, 110k miles, replaced the fan clutch, thermostat, and coolant flush with bmw parts from the dealer. replaced both belts. bled the coolant res. idled the car for 20 minutes, running the heater and then the a c. drove it around for about an hour, put on about 30 miles. no dtc codes, no pending codes.
Bmw E46 Thermostat Replacement Bmw 325i 2001 2005 Bmw 325x Most of the time when you remove the old expansion tank the trans t stat will break. it is best to have one on hand and replace it. the expansion tank sits mounts on top of the automatic transmission thermostat. when you pull the old expansion tank off there's a chance the old thermostat will break. check out this video. 2005 325i e46, automatic trans, 110k miles, replaced the fan clutch, thermostat, and coolant flush with bmw parts from the dealer. replaced both belts. bled the coolant res. idled the car for 20 minutes, running the heater and then the a c. drove it around for about an hour, put on about 30 miles. no dtc codes, no pending codes. My understanding is that you remove the intake, fan, fan shroud, disconnect the hoses, then remove thermostat housing and replace the thermostat. my main question is, should i drain the coolant out from the temperature sensor located down low, or is there a better way to do this and not lose so much fluid? 01 26 2021, 08:39 am. I have recently tried a few things and i have listed them below: replace fuel filter. replace plugs. replace maf sensor. new air filter. new intake throttle gasket. check intake elbow for rips. clean the idle control valve with carburettor cleaner.
Bmw E46 Thermostat Housing And Water Pump Replacement Diy Youtube My understanding is that you remove the intake, fan, fan shroud, disconnect the hoses, then remove thermostat housing and replace the thermostat. my main question is, should i drain the coolant out from the temperature sensor located down low, or is there a better way to do this and not lose so much fluid? 01 26 2021, 08:39 am. I have recently tried a few things and i have listed them below: replace fuel filter. replace plugs. replace maf sensor. new air filter. new intake throttle gasket. check intake elbow for rips. clean the idle control valve with carburettor cleaner.
Comments are closed.