D0 B2 D1 81 D0 B5 D0 Bc D0 B8 D1 80 D0 Bd D1 Cut pvc pipe into the following lengths: 1 x 23″ (top), 2 x 31″ (sides), 1 x 11″ (bottom), 2 x3″ (bottom), and 6 x 12″ (stand pieces) before gluing the pvc pipe, assemble the full strike zone to make sure you have the correct dimensions that everything fits. if everything looks good, disassemble. reassemble one piece of pipe at a time. A regulation size wiffle ball strike zone forms a rectangle, measuring 20 inches in width and 30 inches in height. firstly, mark the 30 inch height on your 2.5 foot pvc pipe. remember, this is where your handy, adjustable pipe cutter comes into play for exact cuts. turn the pipe on its side and mark the 20 inch width.
D0 B1 D0 Bb D0 B0 D0 B3 D0 Be D0 B4 D0 B0 Unlike home plate, in wiffle ball, it’s like a stand (made with plastic wood metal) but functions the same as the counterpart. in general, strike zone dimensions are 36 inches (height) x 24 inches (width) for teens. for kids, you’ve to go a foot smaller. if you want you can make a diy wb strike zone at home. it’ll cost you around $50 $60. The official wiffle ball strike zone has specific dimensions that have been set by the world wiffle ball association (wwba). these dimensions are as follows: the width of the strike zone should be 2 feet. the height of the strike zone should be 1 foot. Materials needed. cut pvc piping into lengths indicated above using hack saw. assemble pvc frame as shown in the picture below to make sure the dimensions are correct, then disassemble. apply pvc primer and then glue inside pvc pipes on ends, then reassemble frame. the only pieces you should not glue together are the bottom t’s to the base. Using your saw or cutters, follow the marked lines to cut out your wiffle ball strike zone neatly. ensure the cuts are straight, to mirror a professional wiffle ball strike zone. secure the zone to a solid structure. after cutting, attach the zone to a supporting object, a pvc pipe, a pole, or even a chair.
Comments are closed.